Isomat Tile Adhesive AK-22

Reference: 0.38.985.023

Upon Order Up to 10 Working Days

€14.37

Tax included

White 25 kg Tile adhesive AK 22 from the company Isomat

Description

Isomat Tile Adhesive AK-22

White 25 kg Tile adhesive AK 22 from the company Isomat
AK 22 is a high-quality cement-based tile adhesive, reinforced with polymeric components (resins)
It provides high initial and final adhesive strength, special flexibility and moisture resistance
It has zero slip and long open paste time
It is classified as type C2 TE S1 adhesive according to EN 12004

Fields of application

Pasting absorbent and non-absorbent tiles (eg gres porcellanato). Natural stone. Decorative plinths. Large-format tiles. Glass mosaics, etc., wall or floor, on various surfaces and especially where the requirements in adhesion, particular flexibility and moisture resistance are particularly high (e.g. old tile layer, floors with underfloor heating, metal surfaces, swimming pools, plasterboard, etc.)

Applicable indoors and outdoors

Features

Form: Cementitious mortar
Water requirement: 7,75 l/bag 25 kg
Application temperature: from +5ºC to +35ºC
Application thickness: up to 15 mm
Pot life: at least 6 h
Open pasting time: at least 30 min
Calibration time: at least 30 min
Slid: ≤ 0.5 mm
Adhesion after: - 28 days: ≥ 1,90 N/mm2 - heating to +70ºC: ≥ 1,90 N/mm2 - immersion in water: ≥ 1,50 N/mm2 - 25 freeze-thaw cycles: ≥ 1,50 N/mm2
Temperature resistance: from -30ºC to +90ºC
Grouting on a wall: after 3-8 h
Grouting on floor: after 24 h
Deformability in accordance with EN 12004-2: > 2,5 mm

Application

Substrate preparation. The surface to be coated must be free from dust, grease, paint, loose materials, etc. It is recommended to wet before application
Application. Add ISOMAT AK 22 to the stirring water until a homogeneous pasty mixture is obtained. It is recommended to mix with a low-speed mixer (drill)
Let the mixture ripen for about 5 minutes and stir it a little again
Spread the glue and "comb" it on the substrate with a serrated spatula, so that it is evenly distributed over the entire surface
Then, we place the tiles, pressing them to the point of their desired position
The layered mixture should be covered with tiles within 30 minutes to avoid "epidermis", i.e. before the adhesive film starts setting
Consumption: 1,5-4,0 kg/m2, depending on the size of the teeth of the spatula and the type of substrate

Notes: The product contains cement, which reacts alkaline with water and is classified as irritant. Highly porous surfaces, such as aerated concrete, plasterboard, particleboard, etc., should be primed initially with the acrylic primer UNI-PRIMER. Consult the instructions for safe use and precautions on the packaging.

Data sheet