Sika Adhesion Bridge and Corrosion Protection of Reinforced Concrete Structures
Adhesion bridge and corrosion protection for concrete structures Sika MonoTop 910 S
Sika MonoTop -910 S is a 1-component, silica fume cementitious mortar, modified with polymers, for use as an adhesion bridge and corrosion protection for steel reinforcement
Advantages
- CE marked according to EN 1504-7
- Applied by brush or spray pump using the wet method
- Easy to apply, just add water
- Good adhesion to concrete and steel
- Features
- Composition Portland Cement, silica fume, powdered dispersion polymers, selected aggregates and additives
- Fresh mortar density: ~ 2,10 kg/l
- Compressive strength ~50 Mpa
- Modulus of elasticity in compression ≥ 20 Gpa
- Tensile strength in bending ~2,0 Mpa
- Coefficient of thermal expansion ~17,5 x 10-6 1/K
Application
- Mixing: Sika MonoTop -910 S can be mixed with an electric mixer at low speed
- Application: As an adhesion bridge: thoroughly wet the prepared surface, 2 hours before application is recommended. Keep it wet and do not allow it to dry. Before application, remove excess water, e.g. with a clean sponge
- The surface should have a dark matt appearance, without shine, and pores and craters should be free of water
- Using a clean brush, roller or suitable spraying equipment, apply a first coat, covering the substrate with a thin film, filling pores, gaps and smoothing the surface
- As corrosion protection. When the first coat has hardened sufficiently (on the nail), apply a second coat of approximately 1 mm thickness. In the case of spray application, protect the substrate from spraying and droplets by wiping off localised concentrations